V1 Drop Kit Universal Frame/Chassis for Lowered, Dropped, Slammed, Pro touring Trucks or Cars 1/24 1/25
V1 Drop Kit Universal Frame/Chassis for Lowered, Dropped, Slammed, Pro touring Trucks or Cars 1/24 1/25
Parts come attached to supports.
Be extra careful when removing the arms from base.
You may need to modify bed or rear section of kit to fit like you want it to.
This universal frame allows a wheel base of up to approximately 165mm.
Frame width at its widest point (middle section) is right under 59mm.
Measure you kit's wheelbase. Cut the long section of the front frame and join to rear section to make the full frame. You can use the extra pieces to make crossbars to reinforce if you wish.
Parts are thin for accuracy to scale so they are prone to warping in high temperatures. Hot/cold water trick helps bend back into shape if needed.
Each set includes:
- Front frame section
- Rear frame section
- 2 bagged a-arms
- Rear end axle
- Rear dual bag setup
- 4 custom brake discs (17mm dia.)
- 4 custom calipers
- Fuel tank
The front suspension is not adjustable but the rear axle does have some room for customization. Additional modifications to your kit may be needed to make this fit the way you want. Sanding is recommended to get to your preferred smoothness.
For additional add-ons:
Compressors and tank can be found here.
Wheel tubs are also available here.
Assembly instructions are not available. We encourage you to use the pictures in this listing for guidance.
Couldn't load pickup availability
Additional details
Additional details
- Parts are 3d printed in resin
- Some parts may come attached to the support tree
- Sprue cutters are recommended to detach parts
- Some pieces are delicate so take your time
- Any brand CA or super glue is recommended
- There are no assembly instructions. Please use the pictures for guidance.
Recommended decal application (if applicable):
Recommended decal application (if applicable):
Make sure the surface is clean and free of any dust. Ensure the surface has a high gloss finish.
Cut out the decal as close to the graphic as possible (do not cut in squares, should be cut with round corners).
- BLUE BACKING PAPER-Soak cut decals in distilled water for 20 - 30 seconds till decal slides freely on paper.(Time will vary-the warmer the water the quicker the decals will release). Don't remove decal from paper (paper is needed to help position decal on the model.
- WHITE BACKING PAPER (neons & metallics) Using warm water soak till decal slides freely on paper (Time will vary 30 seconds or more). Don't remove decal from paper. The paper is needed to help position decal on the model.
Optional: Apply water and/or Microset to the surface of model. Using water with a few drops of Microset is ideal.
Remove decals from water and place on model surface, gently slide decals off paper onto surface. Once decal is in place remove excess water with cotton swab, paper towel or soft paint brush
Disclaimer: Decals are fragile, take time and care when handling to prevent tearing and damaging the decal. We are not responsible for damage during your installation.
Recommended cleanup process:
Recommended cleanup process:
Click here> Recommended Prep
Customer Reviews








