V2 Lift Kit Custom Universal Frame/Chassis for Lifted Raised Off-Road Trucks or Cars 1/24 1/25

Name: V2 Lift Kit Custom Universal Frame/Chassis for Lifted Raised Off-Road Trucks or Cars 1/24 1/25
Brand: IcemanCollections
Price: 35.0 USD
Availability: InStock

You may need to modify bed or rear section of kit to fit like you want it to.

The Universal Frame allows a wheel base of up to approximately 153mm.

Frame width at its widest point (middle section) is approximately 58mm.

Measure you kit's wheelbase. Cut the long section of the front frame and join to rear section to make the full frame. Use the sections you just cut to reinforce the thin section of the frame.

The front suspension is not adjustable but the rear axle does have some room for customization. Additional modifications to you kit may be needed to make this fit the way you want. Sanding is recommended to get to your preferred smoothness.

This is based on fan art suspension. It is a custom lift kit.

Warmer months are here and packages get hot during shipping. Some parts are thin and may warp during transit. The hot/cold water trick will help to straighten them out. We do not recommend you bending them without warming it up. It will snap.

Assembly instructions are not available. We encourage you to use the pictures in this listing for guidance.

If you are not familiar with resin, please research before purchasing. These are not for beginners. As with all resin, this will need some work like sanding smooth, cleaning flash, evening out surfaces, filling pinholes, reshaping, and/or fabricating parts. With the heat that occurs during shipping, some parts may slightly warp. Be prepared to reshape using the hot/cold water method. Parts may come attached to support tree. Resin color may vary from pictures. Color may not match all parts.

$35.00

Sale Sold out

Shipping calculated at checkout.

Product variants

Quantity

Additional details

- Parts are 3d printed in resin
- Some parts may come attached to the support tree
- Sprue cutters are recommended to detach parts
- Some pieces are delicate so take your time
- Any brand CA or super glue is recommended
- There are no assembly instructions. Please use the pictures for guidance.

Recommended decal application (if applicable):

Make sure the surface is clean and free of any dust. Ensure the surface has a high gloss finish.

Cut out the decal as close to the graphic as possible (do not cut in squares, should be cut with round corners).

BLUE BACKING PAPER-Soak cut decals in distilled water for 20 - 30 seconds till decal slides freely on paper.(Time will vary-the warmer the water the quicker the decals will release). Don't remove decal from paper (paper is needed to help position decal on the model.
WHITE BACKING PAPER (neons & metallics) Using warm water soak till decal slides freely on paper (Time will vary 30 seconds or more). Don't remove decal from paper. The paper is needed to help position decal on the model.

Optional: Apply water and/or Microset to the surface of model. Using water with a few drops of Microset is ideal.

Remove decals from water and place on model surface, gently slide decals off paper onto surface. Once decal is in place remove excess water with cotton swab, paper towel or soft paint brush

Disclaimer: Decals are fragile, take time and care when handling to prevent tearing and damaging the decal. We are not responsible for damage during your installation.